Now we employ more than 600 people, operate more than 80 presses, we do coating, ... and we are constantly modernizing.
More than a quarter century of existence
This is a pretty big piece of history and experience
Now we employ more than 600 people, operate more than 80 presses, we do coating, ... and we are constantly modernizing.
In 2010, a new press shop was opened in Králíky and pressing started.
In 2002 - ten years after the company was founded – we made a strategic decision to build a new factory in Bystřec with an area of 1500 m2, where the plastic parts press shop was concentrated.
As the volume of plastic injection molds produced in our company grew, it was necessary to test these molds. Therefore, in 1995, the first injection molding machine was purchased. Later, the plastic molding shop was opened.
Formplast Purkert, s.r.o. was established on 7 July, 1992 by Ing. Zdeněk Purkert.
From the beginning the company was engaged in plastic injection molding. At first, however, construction work for various tool factories was its main activity.
In 2014, a logistics center was built in Bystřec with an area of 3300 m2.
Increasing customer demand prompted further construction of a 3300 m2 production hall, which was completed in 2008. The total area of 4800 m2 allowed for the concentration of all development and production capacities in one place.
In 1998 we started to build a new tool shop in Jablonné nad Orlicí. This tool shop was approved a year later and production started.
Successful introduction of a quality management system, which was subsequently certified according to ISO 9001 standards.
We completed the next stage of development of our company during these years. A tool shop equipped with modern technology began to operate in its own premises.
Now we employ more than 600 people, operate more than 80 presses, we do coating, ... and we are constantly modernizing.
In 2014, a logistics center was built in Bystřec with an area of 3300 m2.
In 2010, a new press shop was opened in Králíky and pressing started.
Increasing customer demand prompted further construction of a 3300 m2 production hall, which was completed in 2008. The total area of 4800 m2 allowed for the concentration of all development and production capacities in one place.
In 2002 - ten years after the company was founded – we made a strategic decision to build a new factory in Bystřec with an area of 1500 m2, where the plastic parts press shop was concentrated.
In 1998 we started to build a new tool shop in Jablonné nad Orlicí. This tool shop was approved a year later and production started.
Successful introduction of a quality management system, which was subsequently certified according to ISO 9001 standards.
As the volume of plastic injection molds produced in our company grew, it was necessary to test these molds. Therefore, in 1995, the first injection molding machine was purchased. Later, the plastic molding shop was opened.
We completed the next stage of development of our company during these years. A tool shop equipped with modern technology began to operate in its own premises.
Formplast Purkert, s.r.o. was established on 7 July, 1992 by Ing. Zdeněk Purkert.
From the beginning the company was engaged in plastic injection molding. At first, however, construction work for various tool factories was its main activity.